Best 7 Reloading – Shotshell Reloading for the money

The mec 9000 gn utilizes mechs autos. Indexing system which automatically advances the shells to the next station we will go through the steps on the. Setup and then the actual reloading sequence that is involved in reloading. On the 9,000 gn the first step in. Setting up the 9000 gn would be to. Attach the ejection chute to the side of. The base using the bolts and nuts supplied in the parts bag the next step. In setting up to 9,000 gn would be to attach the wooden handle grip to the handle after you have selected your. Desired load install the proper powder. Bushing. The next step would be to install the primer seating assembly. Now attach the primer feed to the. Mounting bracket to fill the primer feed. Slide the cover off insert one set of. Primers which would be a hundred slide them in remove the cover install the. Next set of 100 primer feed is capable of holding 200 primers install the. Powder and shot containers and fill with. Proper components. To begin reloading on the 9000 gn slide. An empty shell into station one lowering. The handle d prime’s the shell and. Resizes the brass back to factory specs. At this point when the handle is depressed a primer is also dispersed into the shell carrier upon returning. The handle to the top of the stroke the shell is automatically advanced to. Station number two at station number two. With the down stroke of the handle the primer is seated and when the handle is. Returned to the top the powder is dispersed into the shell and the shell then is advanced to station number three. At station number three slip a wad onto. The ram and depress the handle the shot is then dispersed into the wad the shell. Is then advanced the station number four. When the handles return to the top at. Station number four it puts the pre. Crimp on the shell the necessary steps. With the pre crimp would be to make sure that you pre crimp the shell with the. Same number of folds that it had originally upon return of the handle to. The top the shell is advanced to station. Number five mechs exclusive cam crimps. Die this station closes the shell and sets. The depth of the crimp returning the. Handle to the top — shell advances to station number six at station number six. The desired amount of taper is placed on. The shell when the handle is returned to. The top the shell is ejected down the chute to go into the progressive mode. You’ll simply add a shell to station number one and once three shells are in. The machine you’ll just be adding a shell and placing a wad on the ram the. 9000 gn is capable of reloading three to. Four hundred shells per hour and is available in the following gages 12 16. 20 28 and 410 die sets are not available. For this machine so if you wish to. Reload another gauge you would need another machine.